With most hobby motors being either 6 or 12 Volt, 10 Volt may not be the most practical voltage. The digital part of the MX1508 however is fed through a 220 ohm resistor with the resulting voltage being capped by what I presume to be a zenerdiode of 5 Volt. The module however, has only 1 Voltage input, that supposedly can take 2-10 Volt. has a working voltage of 1.8-5Volt, but can drive motors with an operating voltage of 2-9.6 Volt. The MX1508 from Shenzhen Guanghui Electronics Co., Ltd. The pin spacing is 0.1″ but the various connectors are at aberrant spacing. The module itself is not really breadboard friendly. It is rated at 1.5A on each motor with a peak of 2.5A. It is an H-bridge configuration for each motor and so can drive the motors in either direction. This board can drive two motors independently. Three popular, cheap motordriver boards that are available on chinese webstores are the MX1508, L9110S and TB6612.Īt Aliexpress and Banggood, the MX1508 is listed as a “Dual Channel L298N DC Motor Driver Board PWM Speed Dual H Bridge Stepper Module”.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |